We were previously displaying an address in the "to" field for TransactionPreview. Instead, this is meant to be a contact view.
- Fix ContactSelector to trigger selectedContactChanged
- Fix RecipientSelector > ContactSelector to trigger resolveEns from outside call to prevent infinite loop from the above fix
- Add alias to pre-selected contact for the Contact view of TransactionPreview
- Add option to change debounce delay so that when values are pre-selected (readonly), there is no delay before resolution.
- Fix missing tx data param in walletModel.estimateGas
feat: Re-enable contact selection in the wallet send dialog
Selecting a ENS-verified contact will resolve it's ENS address so transactions can be sent directly to contacts from the wallet (if and only if they have ENS enabled for their account).
feat: add EnsResolver component that shows a loader and allows automated ENS resolution from within QML
BalanceValidator and GasValidator have been moved outside of the TransactionPreview component, because there are some transaction modals that may not need them to be baked in to TransactionPreview. It is useful to have these components on the tx preview step only when we start the process on the preview step.
Fixes#1202
I had to revert the loader changes that switched from/to as it was causes quite a lot of logistical complexity. Instead of using Loaders, we are setting the type of account (account or contact), and it is being displayed appropriately. There is a very slight deviation from the design, however it is consistent with the design for other transaction previews.
feat: add BalanceValidator
Shows an exclamation icon next to the "from" account when the balance for the requested asset is too low.
This is useful when the user starts the transaction wizard on the TransactionPreview step.
fix: SignTransactionModal - set default focused account when none is found
refactor: move token lookup from QML to nim in the toMessage procedure.
fix: 1:1 tx requests - handle case where token contract is not found (ie sending SNT from mainnet and receiving message on testnet)
feat: error checking for building a token transaction
feat: TransactionPreview - add a validation check that disallows continuation if the selected "from" account has insufficient funds
I noticed that the 1:1 chat commands were not able to send token transactions due to "intrinsic gas too low" error. I quickly realised there there were a few components missing, which have been fixed.
*feat: update the 1:1 chat commands transaction modal to allow editing of the from account and network fee*
The TransactionStackGroup was updated slightly to allow manual control of back/next actions.
Fixes#870.
*fix: Create distinct modal transaction actions*
Previously, adding `Connection`s for the `walletModel.transactionWasSent` signal in different dialogs would cause the signal to be handled in the wrong dialog. The solution was to pass a `uuid` from the requesting dialog, and include the `uuid` in the response, so that only requests that were requested from the dialog would be handled.
*fix: update 1:1 translations*
All the translations were not being translated for me. I noticed that they did not exist in the `.ts` translation files either.
- Create privilege dialogs dynamically for each privilege requested
- Check if a privilege has been granted before to determine if dialog must be shown or not
- If dapp is allowed to use privilege, save it in the settings
