When there are a lot of deposits, we decompress the public key into a
crypto cache. To avoid having those caches grow unreasonably big,
make sure to operate on the decompressed pubkey instead.
* more efficient forkchoiceUpdated usage
* await rather than asyncSpawn; ensure head update before dag.updateHead
* use action tracker rather than attached validators to check for next slot proposal; use wall slot + 1 rather than state slot + 1 to correctly check when missing blocks
* re-add two-fcU case for when newPayload not VALID
* check dynamicFeeRecipientsStore for potential proposal
* remove duplicate checks for whether next proposer
`news` has a few open issues that are not present in `nim-websock`:
1. There is a 1 second delay between each MB of sent data.
2. Cancelling an ongoing `send` makes the entire WebSocket unusable.
3. Control packets do not have priority over ongoing message frames.
Using `news`, there are quite a few of these messages in Geth:
```
Previously seen beacon client is offline. Please ensure it is
operational to follow the chain!
```
It may take quite some time to reconnect when this happens.
Using `nim-websock`, this message still occurs because `eth1_monitor`
reconnects the EL connection when no new blocks occurred for 5 minutes,
but reconnecting is quick and the message is rarer.
The sync protocol does not distinguish between:
- All requested slots are empty
- Peer does not have data available about requested range
Therefore, we treat EOF for `beacon_blocks_by_range` and for
`beacon_blocks_by_range` as valid responses, as if the entire epoch
really contained no single block for any slot. Once a followup response
provides new blocks, we detect that some blocks were missing and rewind.
During backfill, we also request the known-to-exist `backfill.slot`,
so we can actually detect whether an epoch really does not have blocks
or whether a response is incomplete (`PeerScoreNoBlocks`).
When the BN-embedded LC makes sync progress, pass the corresponding
execution block hash to the EL via `engine_forkchoiceUpdatedV1`.
This allows the EL to sync to wall slot while the chain DAG is behind.
Renamed `--light-client` to `--sync-light-client` for clarity, and
`--light-client-trusted-block-root` to `--trusted-block-root` for
consistency with `nimbus_light_client`.
Note that this does not work well in practice at this time:
- Geth sticks to the optimistic sync:
"Ignoring payload while snap syncing" (when passing the LC head)
"Forkchoice requested unknown head" (when updating to LC head)
- Nethermind syncs to LC head but does not report ancestors as VALID,
so the main forward sync is still stuck in optimistic mode:
"Pre-pivot block, ignored and returned Syncing"
To aid EL client teams in fixing those issues, having this available
as a hidden option is still useful.
When issuing an engine API call while the EL is disconnected, a `nil`
pointer is dereferenced. Fixed by correctly initializing futures.
```
Traceback (most recent call last, using override)
vendor/nim-libp2p/libp2p/protocols/pubsub/pubsub.nim(890) main
beacon_chain/nimbus_beacon_node.nim(2139) main
beacon_chain/nimbus_beacon_node.nim(0) handleStartUpCmd
beacon_chain/nimbus_beacon_node.nim(0) doRunBeaconNode
beacon_chain/nimbus_beacon_node.nim(0) start
beacon_chain/nimbus_beacon_node.nim(1589) run
vendor/nimbus-build-system/vendor/Nim/lib/system/iterators_1.nim(107) poll
vendor/nim-chronos/chronos/asyncfutures2.nim(365) futureContinue
beacon_chain/consensus_object_pools/consensus_manager.nim(297) updateHeadWithExecution
vendor/nim-chronos/chronos/asyncmacro2.nim(213) runProposalForkchoiceUpdated
vendor/nim-chronos/chronos/asyncfutures2.nim(365) futureContinue
beacon_chain/consensus_object_pools/consensus_manager.nim(259) runProposalForkchoiceUpdated
beacon_chain/eth1/eth1_monitor.nim(0) forkchoiceUpdated
vendor/nim-chronos/chronos/asyncfutures2.nim(219) complete
vendor/nim-chronos/chronos/asyncfutures2.nim(149) cancelled
vendor/nimbus-build-system/vendor/Nim/lib/system/excpt.nim(610) signalHandler
SIGSEGV: Illegal storage access. (Attempt to read from nil?)
```
The optimistic sync spec was updated since the LC based optsync module
was introduced. It is no longer necessary to wait for the justified
checkpoint to have execution enabled; instead, any block is okay to be
optimistically imported to the EL client, as long as its parent block
has execution enabled. Complex syncing logic has been removed, and the
LC optsync module will now follow gossip directly, reducing the latency
when using this module. Note that because this is now based on gossip
instead of using sync manager / request manager, that individual blocks
may be missed. However, EL clients should recover from this by fetching
missing blocks themselves.
When the EL fails to respond to `newPayload`, e.g., because connection
to the EL got interrupted, or due to misconfiguration, optimistic blocks
cannot be imported according to spec. This condition is treated the same
as if the peer returned a block with missing parent which gets the block
out of our processing queue, but can have nasty side effects.
For example, if sync manager asks for validation of a block known to be
in the finalized range, if it receives a `MissingParent` verdict, the
peer is immediately removed from the peer pool.
```
DBG 2022-08-24 11:45:26.874+02:00 newPayload: inserting block into execution engine parentHash=e4ca7424 blockHash=36cdc198 stateRoot=cf3902c1 receiptsRoot=56e81f17 prevRandao=0b49a172 blockNumber=1518089 gasLimit=30000000 gasUsed=0 timestamp=1657980396 extraDataLen=0 baseFeePerGas=7 numTransactions=0
ERR 2022-08-24 11:45:26.875+02:00 newPayload failed msg="Transport is not initialised (missing a call to connect?)"
DBG 2022-08-24 11:45:26.875+02:00 Block pool rejected peer's response topics="syncman" request=187232:32@1475 peer=16U*MsCJdx direction=forward blocks_map=xxxxxxxxxxxxxxxxxxxxxxxxxxxx.xxx blocks_count=31 ok=false unviable=false missing_parent=true sync_ident=main
ERR 2022-08-24 11:45:26.875+02:00 Unexpected missing parent at finalized epoch slot topics="syncman" request=187232:32@1475 peer=16U*MsCJdx direction=forward rewind_to_slot=187232 blocks_count=31 blocks_map=xxxxxxxxxxxxxxxxxxxxxxxxxxxx.xxx sync_ident=main
DBG 2022-08-24 11:45:26.875+02:00 Peer was removed from PeerPool due to low score topics="beacnde" peer=16U*MsCJdx peer_score=-1000 score_low_limit=0 score_high_limit=1000
DBG 2022-08-24 11:45:26.875+02:00 Lost connection to peer topics="networking" peer=16U*MsCJdx connections=0
```
By delaying issuing a verdict until the EL connection is restored and
`newPayload` successfully ran, the problem should be fixed. This also
induces back pressure to the sync manager by stopping download of new
blocks (or re-downloading the same block over and over again).
* Harden block proposal against expired slashings/exits
When a message is signed in a phase0 domain, it can no longer be
validated under bellatrix due to the correct fork no longer being
available in the `BeaconState`.
To ensure that all slashing/exits are still valid, in this PR we re-run
the checks in the state that we're proposing for, thus hardening against
both signatures and other changes in the state that might have
invalidated the message.
* fix same message added multiple times
in case of attestation slashing of multiple validators in one go
* support connecting to peers without bellatrix
Make discovery fork ID aware of scheduled Bellatrix fork to enable
connections to peers that don't have Bellatrix scheduled yet.
Without this, has peering issues with peers on older SW version.
* expand tests with compatibility checks
* more exhaustive compatibility checks
Aligns the default retention policy for LC data with the one for blocks.
Minimum spec requirement for both blocks and LC data is ~5 months.
Additional use cases are better supported by retaining data for longer.
* Fixes a segfault during block production when the Keymanager API
is disabled. The Keymanager is now disabled on half of the local
testnet nodes to catch such problems in the future.
* Fixes multiple potential stalls from REST requests being done
without a timeout. From practice, we know that such requests
can hang forever if not cancelled with a timeout. At best,
this would be a resource leak, at worst, it may lead to a
full stall of the client and missed validator duties.
* Changes some Options usages to Opt (for easier use of valueOr)
When the client was started without any validators, the doppelganger
detection structures were never initialized properly. Later, when
validators were added through the Keymanager API, they interacted
with the uninitialized doppelganger detection structures and their
duties were inappropriately skipped.
* Keymanager API for the validator client
* Properly treat the 'description' field as optional when loading Keystores
* Spec-compliant serialization of the slashing data in Keymanager's DeleteKeys response ()
Fixes#3940Fixes#3964Closes#3884 by adding test
In order to avoid full replays when validating attestations hailing from
untaken forks, it's better to keep shufflings separate from `EpochRef`
and perform a lookahead on the shuffling when processing the block that
determines them.
This also helps performance in the case where REST clients are trying to
perform lookahead on attestation duties and decreases memory usage by
sharing shufflings between EpochRef instances of the same dependent
root.
* packaging updates
* one package per binary (nimbus_beacon_node, nimbus_validator_client)
* use `-` in package name (`_` is separating the version)
* don't include (un)installation scripts in package
* default metrics port 8108 for vc
* fix several upgrade/install errors in scripts
* add JWT option to service files
* don't attempt to remove user on purge
* import EL deposits even when EL is stuck
The `eth1_monitor` only starts importing deposits once the EL reports a
new head block. However, the EL may be stuck at a block, e.g., the TTD.
By polling the latest EL block once after subscribing to new EL block
events it is ensured that deposits are still imported in this situation.
* also poll once on re-connects
* update `eth1_latest_head` metric in poll mode
* add comment about similar polling vs events parts
* replace check with assert
* `isNewLastBlock` helper
When fetching eth1 data and deposits for a new block proposal, the list
of deposits from previous eth1 data to the next one is fully loaded into
a `seq`. This can potentially be a very long list in active periods.
Changing this to an `iterator` saves memory by ensuring that the entire
list is no longer materialized; only the `DepositData` roots are needed.
When the EL connection is interrupted, deposits are once more requested
in chunks of 5000 blocks. This is a problem when the response takes over
a minute to produce and consistently times out as followup requests with
lower chunk sizes may no longer work after a request was canceled, e.g.,
when using Geth with websockets. By keeping track of `blocksPerRequest`
across EL reconnections, it is possible to recover from this by avoiding
to continuously repeat the initial request with the full 5000 blocks.
Also cleans up one more "retry of retry" instance; `DataProviderTimeout`
is a `CatchableError` and already handled by the existing retry logic.
When connection to the EL is lost as part of EL deposits importing, the
targeted block range to sync would reset. This is changed to properly
remember import progress across reconnects.
https://github.com/status-im/nimbus-eth2/pull/3944
The use of nested `awaitWithRetries` calls would have
resulted in an unexpected number of retries (3x3).
We now use regular `await` in outer layer to avoid the problem.
https://github.com/status-im/nimbus-eth2/pull/3943
The new code has an invariant that the `headMerkleizer` field in
the `Eth1Chain` is always kept in sync with the blocks stored in
the chain.
This invariant is now enforced better by doing the necessary merkleizer updates
in the `Eth1Chain.addBlock` function, in the `Eth1Chain.init` function and in the
`Eth1Chain.reset` function.
When importing blocks with deposits from the EL, the timestamp is never
initialized for them. Therefore, only blocks without deposits (for which
the timestamp is obtained) are considered for `is_candidate_block`.
This is fixed by also importing timestamps for blocks with deposits.
* fix obtaining deposits after connection loss
When an error occurs during Eth1 deposits import, the already imported
blocks are kept while the connection to the EL is re-established.
However, the corresponding merkleizer is not persisted, leading to any
future deposits no longer being properly imported. This is quite common
when syncing a fresh Nimbus instance against an already-synced Geth EL.
Fixed by persisting the head merkleizer together with the blocks.
* MEV validator registration
* add nearby canary to detect new beacon chain forks
* remove special MEV graffiti
* web3signer support
* fix trace logging
* Nim 1.2 needs raises Defect
* use template rather than proc in REST JSON parsing
* use --payload-builder-enable and --payload-builder-url
* explicitly default MEV to disabled
* explicitly empty default value for payload builder URL
* revert attestation pool to unstable version
* Use final `v1` version for light client protocols
* Unhide LC data collection options
* Default enable LC data serving
* rm unneeded import
* Connect to EL on startup
* Add docs for LC based EL sync
tersec
Etan Kissling
Jacek Sieka
Tanguy
Zahary Karadjov
Eugene Kabanov
Miran
Taneli Hukkinen