Disable some trace messages which appeared a lot in the output and probably
aren't so useful any more, when block processing is functioning well at high
speed.
Turning on the trace level globally is useful to get a feel for what's
happening, but only if each category is kept to a reasonable amount.
As well as overwhelming the output so that it's hard to see general activity,
some of these messages happen so much they severely slow down processing. Ones
called every time an EVM opcode uses some gas are particularly extreme.
These messages have all been chosen as things which are probably not useful any
more (the relevant functionality has been debugged and is tested plenty).
These have been commented out rather than removed. It may be that turning
trace topics on/off, or other selection, is a better longer term solution, but
that will require better command line options and good defaults for sure.
(I think higher levels `tracev` and `tracevv` levels (extra verbose) would be
more useful for this sort of deep tracing on request.)
For now, enabling `--log-level:TRACE` on the command line is quite useful as
long as we keep each category reasonable, and this patch tries to keep that
balance.
- Don't show "has transactions" on virtually every block imported.
- Don't show "Sender" and "txHash" lines on every transaction processed.
- Don't show "GAS CONSUMPTION" on every opcode executed", this is way too much.
- Don't show "GAS RETURNED" and "GAS REFUND" on each contract call.
- Don't show "op: Stop" on every Stop opcode, which means every transaction.
- Don't show "Insufficient funds" whenever a contract can't call another.
- Don't show "ECRecover", "SHA256 precompile", "RIPEMD160", "Identity"
or even "Call precompile" every time a precompile is called. These are
very well tested now.
- Don't show "executeOpcodes error" whenever a contract returns an error.
(This is changed to `trace` too, it's a normal event that is well tested.)
Signed-off-by: Jamie Lokier <jamie@shareable.org>
why:
the v2 prefix of the file name was used as a visual aid when
comparing vm2 against vm sources
details:
all renamed v2*.nim sources compile locally with the -d:kludge:1 flag
set or without (some work with either)
only sources not renamed yet: v2state_transactions.nim
why:
these files provide part of the externally accessible interface
provided by vm_message.nim, vm_precompile.nim, vm_gas_cost.nim. so the
new filename indicates that the source code belongs to vm2 (rather
than vm).
why:
these files provide part of the externally accessible interface
provided by vm_types*.nim. so the new filename indicates that the
source code belongs to vm2 (rather than vm).
why:
making sure that deep links into vm2 sources are configured properly. it
is intended that only the vm_*.nim interface headers are allowed to
source files in vm2. the sentinels just protect from coding errors.
why:
vm2 enabled by ENABLE_VM2=1 behaves as vm without ENABLE_EVMC=1 until
it doesn't in some future fatch set. this leaves some wiggle room
to work on a vm copy without degrading the original implementation.
details:
+ additional make flag ENABLE_VM2=1 (or ENABLE_VM2=0 to explicitely disable)
+ when both flags ENABLE_EVMC=1 and ENABLE_VM2=1 are present, the former
flag ENABLE_EVMC=1 takes precedence, this is implemented at the NIM
compiler level for -d:evmc_enabled and -d:vm2_enabled
Jacek Sieka
jangko
Jamie Lokier
Jordan Hrycaj