* Using unsigned types for message type and requst IDs
why:
Negative values are neither defined for RLP nor in the protocol specs
which refer to the RLPs (see yellow paper app B clause (199).
* Fix `int` argument (must be `uint`) in fuzzing tests
why:
Not part of all tests so it slipped through.
A first step in cleaning up RLP, which has lots of interesting issues -
the next step would be to clean up the exception handling as well
(Resultify?)
* remove `RlpNode` (unused)
* single-pass parsing for most functionality via RlpItem
* stricter conformance to spec
* remove float support
* warn about signed integers
* raise on invalid RLP earlier
* avoid several pointless allocations, in particular in `listLen`,
`listElem` etc
* include spec docs
RLP Enum deserialization would currently not check if "hole values"
were attempted to be converted to the enum type. Now use
checkedEnumAssign and fail with RlpTypeMismatch on invalid values.
There is at least one occurance of an enum with holes in rlpx p2p:
DisconnectionReason. For this enum the issue could occur.
Also:
- Added enum RLP tests and rlpx p2p disconnect message tests to
test the DisconnectionReason with enum hole value.
- Fixed worse custom DisconnectionReason decoding occurance
in rlpx in waitSingleMsg proc where this issue could occur.
* Provide dedicated `DisconnectionReason` enum type RLP reader
why:
Without this reader, the program communicating via RLPX will crash when
receiving out of bound reason codes disconnect message.
Out of bound value assignments to an enum causes a `RangeError`defect
and consequently the program to terminate. This `RangeError` is avoided
here and a `MalformedRlpError` catchable error raised.
* Using default exception type in bespoke `read(DisconnectionReason)`
why:
This should not differ from the default enum parser. The particular
message is different and more targeted, here.
Note: The default RLP parser was not used because `
`array[1,DisconnectionReason]` is currently not properly handled and
should give a siliar error message as a `DisconnectionReason` error.
* De-clutter, custom read() was not needed
Co-authored-by: jordan <jordan@curd.mjh-it.com>
why:
Rlp errors throw exceptions which cause the dispatcher loop to
terminate the current session immediately.
details:
The DisconnectionReasonList message requires a single entry list.
Observed and now accepted deviations are:
Geth: single byte number
bor(a Geth fork): blobbed single entry list containing a number
Jordan Hrycaj
Jacek Sieka
Kim De Mey
oskarth
Jordan Hrycaj